Login
beer lambert lawModerator: BioTeam
4 posts
• Page 1 of 1
beer lambert lawhi all im using the beer law to find my protein's concentration at A280.
c= A/(epsilon)(c) i have found a paper which says the concentration of CS was determined using molar absorption coefficent of 1.78 for a 1mg/ml solution. WHAT DOES THIS 1MG/ML SOLUTION MEAN. IS BELOW CORRECT is this correct then i found A280 = 1.157 c= 1.157/ 1.78(1) c= 0.65M my stock is therefore 0.65M concentration.
Re: beer lambert lawThe stated coefficient is in the wrong units to be a molar absorptivity (or molar extinction coefficient). That would be in units of A per M (per 1 cm pathlength, but a 1 cm pathlength is usually assumed). If I understand what you said, a 1 mg/ml solution (in a 1 cm pathlength) has an A280 of 1.78 (epsilon = 1.78 A280/1mg/ml/cm), and that will be the extinction coefficient, but not the molar extinction coefficient. You’ve used the coefficient correctly, but the concentration will be 0.65 mg/ml, not M.
Re: beer lambert lawYour units are not correct based on the given information.
First, the Beer's law equation is A=c(epsilon)l. I assume that you have a 1cm light path length through your cuvette and that your figure for epsilon (the absorbance of a 1 mg/ml solution) is calibrated for a 1 cm path length and so epsilon has units of (mg/ml)^-1 cm^-1. Watch out, you were not given the molar absorption coefficient! Instead, you were given an absorbance in units of mg/ml. Solving for c (the concentration) gives: c=A/(epsilon * l) For your setup, A = 1.157 epsilon = 1.78 (mg/ml)^-1 cm^-1 (I must assume that was measured in the same solvent systemyou are using and at 280 nm, but you should check) l = 1 cm c = A/(epsilon * l) = 1.157/(1.78 * 1) = 0.65 mg/ml For units, note that A has no units (dimensionless), epsilon is in (mg/ml)^-1 cm^-1 and l is in cm. Plug these into the Beer's law eq'n: c=A/(epsilon * l) The cm unit cancels, so the units of the concentration are 1/(mg/ml)^-1 = mg/ml If you need the result as a molarity, you will need to get the molecular mass of the protein you are measuring and convert mg/ml to moles/l. Last edited by jonmoulton on Tue Oct 07, 2008 10:34 pm, edited 1 time in total.
Re: beer lambert lawthanks so much guys! you've cleared it up completely.
have a nice day!
4 posts
• Page 1 of 1
Who is onlineUsers browsing this forum: No registered users and 2 guests |
© Biology-Online.org. All Rights Reserved. Register | Login | About Us | Contact Us | Link to Us | Privacy Policy |